Manual

CARE & USE/INSTALLATION
|
29
• Do not use metallic abrasives and always rub in the
direction of the grain.
• Some household cleaning products are not suitable for
stainless steel and high heat; be sure to read the label
before using on your SmartGrill by Lynx™.
• Always use the mildest cleaning solution first, scrubbing
in the direction of the grain. Specks of grease may gather
in the grain of the stainless steel and bake onto the
surface, giving the appearance of rust.
To remove these baked on foods, use a fine to medium
grit non-metallic abrasive pad (Scotch Brite is good) in
conjunction with a stainless steel cleaner.
• Solutions used for cleaning concrete and masonry can
be very corrosive and will attack stainless steel. Ensure
your Lynx products are well protected before you
allow the use of such chemicals near your grill.
SPECIAL NOTE FOR LOCATIONS NEAR POOLS AND
COASTAL AREAS:
The 304 stainless steel material used in the construction of
a Lynx SmartGrill by Lynx™ is highly rust resistant, however
chlorine in the air from swimming pools or salt in the sea
air may cause surface rust to appear and even create some
pitting if left on the product.
Here are a few tips to avoid this:
• Regularly wipe down the exterior surfaces with a damp
cloth (Micro fiber cloths such as Ecloth perform very well.)
• Allow the surfaces to dry before installing the cover. Do
not cover a damp grill.
• In extreme environments, apply a rust inhibitor which
leaves a microscopic protective layer on the grill. Products
that provide a layer of vapor corrosion inhibitors (VpCl™)
protect the surface very well.
• For seasonal storage use the product referred to above,
ensure the grill is dry and then cover and secure the
cover to minimize the amount of damp air getting to the
surfaces.
THE LYNX LIMITED LIFETIME WARRANTY PROVIDES
PROTECTION AGAINST RUST THROUGH OF PARTS THAT
RENDER THE PRODUCT INOPERATIVE. IT DOES NOT
COVER OCCASIONAL SURFACE RUST OR STAINING DUE
TO ENVIRONMENTAL CONDITIONS.
After your first use, certain areas of the grill may discolor
from the intense heat given off by the burners – this is
normal and cannot be cleaned off.
For light and heavy food stains there are many different
stainless steel cleaners available.
DRIP TRAY
The drip tray should be cleaned after each use. After the
grill is completely cool, remove the drip tray by pulling it
forward and up, lifting it out.
It can be wiped down with a paper towel.
PROSEAR2 BURNERS
With the hood up, turn all burners on high for 5 minutes.
Do not touch the ceramic surfaces, and do not use water or
cleaner on the ceramic surface. Do not poke anything into
the holes in the ceramic.
Every three to six months, remove the burners and inspect
the venturi (inlet) and orifice to ensure they are free of
obstructions.
Food debris on the inside of the burners can be gently
shaken out.
While the burners are removed, remove the grease and
debris off the bottom of the firebox.
When re-installing the ProSear™2 burners, be sure to
correctly position the burners.
CLEANING YOUR SMARTGRILL BY LYNX™ ...continued
DO NOT ALLOW EXCESS GREASE OR LIQUIDS
TO ACCUMULATE IN THE DRIP TRAY AS THIS
MAY CREATE A FIRE HAZARD.
NEVER USE GRILL WITHOUT DRIP TRAY
PROPERLY INSTALLED.
WARNING