Manual

32
|
CARE & USE/INSTALLATION
TROUBLESHOOTING ...continued
• Is the cylinder almost empty?
Almost empty cylinders may not have sufficient pressure to
run the burners at high heat.
• Have the line pressure checked by a qualified technician.
• Flow limiting device.
Improper lighting procedure may have activated the liquid
propane cylinder’s flow control device, reducing heat
output.
To reset the flow control:
• Shut off all burner controls and close the liquid propane
cylinder valve.
• Open one gas valve to relieve any pressure in the LP
hose, then close the gas valve
• Wait 30 seconds and, very slowly, reopen the cylinder
valve.
Wait a few seconds and relight a burner.
Bulk Liquid Propane cylinder users:
Bulk liquid propane cylinder lines must be properly
regulated.
Ensure that you are using a 4/11 appliance regulator
supplied by Lynx and converted to liquid propane gas.
Also, ensure that you do not have more than one regulator
in line.
Natural Gas Units:
• Supply line
Ensure that the supply line is at least ¾” inside diameter or
1” outside diameter.
• Check Line pressure
Natural gas inlet pressure should be at least 5” W.C. and
manifold pressure not less than 4” W.C. under full load
(with all burners on).
• Check burners for blockages.
LOW OR INSUFFICIENT HEAT
Proper levelling during installation is critical. A grill that
is out of level will cause erratic burner combustion and
inefficient, uneven heating. A carpenter’s spirit level should
be used to level the grill both front-to-back and side-to-
side.
If the low heat problem persists:
• Check the gas supply line sizing requirements.
• Check the gas supply line for kinks or damage.
• Check the thermostatic control for proper operation.
LIGHTS WON’T LIGHT
• For the blue LED lights and white halogen lights
• Check power
Ensure that the grill is connected to a live AC power
source.
SMARTGRILL SELF-DIAGNOSIS
Your SmartGrill by Lynx™ technology includes self-
diagnosis of some issues and will let you know either
with an audible statement of the issue, or send you a text
message displayed in your app. "Burner <N>" indicates
the SmartGrill will tell you if it is Burner 1, 2, 3, or the Top
Burner (rotisserie). Any time a burner does not light, the
SmartGrill will turn that burner off.
Audible: "Burner <N> igniter malfunctioned."
Text: "Igniter failed to start."
Indicates the igniter has a problem. Check to see if gas is
turned on. Wait 5 minutes for the gas to dissipate, then try
lighting it again. Call Lynx at 888-289-5969.
Audible: "Burner <N> ignition malfunction."
Text: "Burner <N> failed to ignite ."
Indicates the burner is not lit. Check to see if gas is turned
on. Wait 5 minutes for the gas to dissipate, then try lighting
it again. If it still does not light, call Lynx at 888-289-5969.
Audible: "Burner <N> could not stabilize."
Text: "Burner <N> failed to stabilize.
The burner was set a little too cool. Wait 5 minutes for the
gas to dissipate, then light it again. Leave it on high for a
little longer to heat up before adjusting it down to your
target temperature.
Audible: "Burner <N> cannot reach target temperature."
Text: "Burner <N> cannot reach target temperature."
Check to see if gas is turned on. Wait 5 minutes for the
gas to dissipate, then try lighting it again. If it still does not
light, call Lynx at 888-289-5969.
Audible: "Burner <N> has no flame."
Text: "Burner <N> has no flame."