- Lynx Gas Grill Installation Care & Use Manual
either for installation in a
either for installation in a
or for an installation in a built
in enclosure constructed of
combustible material when
installed with a Lynx insulating
jacket (LIJ).
tions, the grill drops into the
tions, the grill drops into the
opening shown in the cutout
tions, the grill drops into the
opening shown in the cutout
tions, the grill drops into the
detail drawing
opening shown in the cutout
detail drawing
opening shown in the cutout
and hangs from
detail drawing
and hangs from
detail drawing
not required to support it from
not required to support it from
the bottom.
not required to support it from
the bottom.
not required to support it from
When using the insulated
jacket in a combustible
enclosure, the jacket must be
supported from the bottom by
enclosure, the jacket must be
supported from the bottom by
enclosure, the jacket must be
a ledge on each side or a full
supported from the bottom by
a ledge on each side or a full
supported from the bottom by
deck beneath the jacket.
provisions shown for gas line
provisions shown for gas line
provisions shown for gas line
provisions shown for gas line
The enclosure should have
ventilation holes to prevent
ventilation holes to prevent
ventilation holes to prevent
a leak. The deck ledges and
a leak. The deck ledges and
a leak. The deck ledges and
a leak. The deck ledges and
Enclosures
F
or Self
C
ontained
local codes for additional
local codes for additional
local codes for additional
information)
BUSTIBLE M
ATERIALS
:
M
inimum clearance from the
sides and back of the grill to
adjacent combustible con
struction below the top of
adjacent combustible con
struction below the top of
adjacent combustible con
struction below the top of
struction below the top of
and back.
D
égagement minimal entre
les parois latérales et l’arrière
de l’appariel et la construc
les parois latérales et l’arrière
de l’appariel et la construc
les parois latérales et l’arrière
de l’appariel et la construc
de l’appariel et la construc
du panneau supérieur de
du panneau supérieur de
du panneau supérieur de
partir de l’arrière).
partir de l’arrière).
M
inimum clearance from
sides and back of unit to
adjacent combustible con
struction extending above the
struction extending above the
struction extending above the
back.
D
égagement horizontal
minimal entre les parois
A
3
inch clearance is required behind the grill to allow the front
hood to open.
inch clearance is required behind the grill to allow the front
hood to open.
inch clearance is required behind the grill to allow the front
The grill exhausts combustion products and cooking greases to
The grill exhausts combustion products and cooking greases to
The grill exhausts combustion products and cooking greases to
The grill exhausts combustion products and cooking greases to
The grill exhausts combustion products and cooking greases to
to clean.
(3” min)(3” min)(3” min)
(3” min)(3” min)(3” min)
latérales et l’arrière de
l’appariel et la construction
l’appariel et la construction
l’appariel et la construction
D
o not use this appliance
under overhead combustible
o not use this appliance
under overhead combustible
o not use this appliance
surfaces.
N
e pas utiliser cet appareil
sous une surface combus
e pas utiliser cet appareil
sous une surface combus
e pas utiliser cet appareil
tible.
is needed on the left side of
the grill above the counter
top for the motor and skewer.
the grill above the counter
top for the motor and skewer.
the grill above the counter
If the grill is to be placed into
a combustible enclosure, an
If the grill is to be placed into
a combustible enclosure, an
If the grill is to be placed into
approved insulated jacket
is necessary and is available
approved insulated jacket
is necessary and is available
approved insulated jacket
only from your Lynx dealer.
is necessary and is available
only from your Lynx dealer.
is necessary and is available
Lynx insulated jackets have
been designed and tested
been designed and tested
been designed and tested