User Manual

Lynx Mixer Reference

SRC Enable

This checkbox will only appear when using an AES16e-SRC. This checkbox controls the state of the

sample rate converter for a specific digital input. When checked, the incoming signal is routed through the

sample rate converter so the sample rate will match the currently selected sample rate of the AES16e-SRC.

For example, when the device connected to Digital In 5 is running at 48 kHz, the AES16e-SRC is running

at 44.1 kHz, and SRC Enable for Digital In 5 is ON, the AES16e-SRC will convert the sample rate from 48

kHz to 44.1 kHz and the SRC Ratio (see below) will indicate approximately 0.918:1.

SRC Ratio

This indicator will only appear when using an AES16e-SRC. Indicates Sample Rate Conversion Ratio

when the SRC Enable checkbox is turned on.

r Digital Outputs Control Section

This section provides control of status bits embedded in the AES/EBU stream for each digital output. For

more information about the use of these bits, refer to the AES-3 specification available from the Audio

Engineering Society web site at http://www.aes.org

Valid

This checkbox controls the state of the Valid bit. When checked, the Valid bit is turned on to indicate to the

receiving device that the audio data being transmitted is valid. This is the default state.

Non-PCM

This checkbox controls the state of the Non-PCM channel status bit. When checked, the Non-PCM bit is

turned on to indicate that audio data other than linear PCM (such as Dolby AC3 or DTS) is being

transmitted.

Emphasis

This checkbox controls the state of the emphasis channel status bits. When checked, the 50/15us emphasis

mode is indicated in the transmitted channel status.

AES16e User Manual

Page 43