User Manual

LS-AES
Page 11
LStream Output Channel Group Mapping
The mapping of the digital mixer’s output channels to LStream channels can be controlled to
accommodate specific I/O configuration requirements. The Output Select control (labeled “1-8/9-16
Select” in the diagram above) allows the destination of the upper eight and lower eight mixer output
channels to be altered. This feature is particularly useful for re-routing output channels 1 – 8, which
are hardwired to the host card’s analog and digital outputs and to the LStream ports.
The Output Select control on the LStream page of the LynxTWO/L22 Mixer has two settings:
9-16/1-8 Maps mixer output channels 9-16 to LStream output channels 1-8. This is the default
setting.
1-8/9-16 Maps mixer output channels 1-8 to LStream output channels 1-8.
Typically, the default setting is easiest to work with since the LS-AES uses only the first eight
LStream channels. This setting utilizes digital mixer outputs that are independent of those connected
to the host card’s analog and digital outputs.
Please note that this section pertains to the mapping of LStream channels, and not to LS-AES output
channels. As will be discussed in a later section there is not always a one-to-one correspondence
between LStream channels and LS-AES I/O channels.