Operation Manual

Page 20
9. Launch the AES16e/LT-TB Update application.
10. Verify that the New Firmware Version is higher than the Current Firmware Version. If so, click “Update”
11. Follow the prompts. When the updater is complete, you will be prompted to turn the computer off (not a
reboot). Click “POWER OFF” and the computer will be shut off automatically. Wait three seconds, then turn
the computer back on.
12. The new LT-TB firmware will now be active.
Also after programming, the settings you had on the unit previously, including saved scenes, may need to be re-
established. This depends on the number and type of differences between the older firmware and the newer.