Operation Manual

Page 48
4.7.2 Return to Meters
Hilo will revert to the Meters screen after some period of inactivity. The default period is 15 seconds. This is where
you can change that delay time.
• Shows the current Menu Delay
• This sets the time that any menu, selection page, pop up menu or
status page will stay active before the screen defaults back to the
selected Meter page. The only menu page that does not “time out” is
the Output Mix Routing Page.
• Pushing the button engages a horizontal fader that lets you set the
delay to 15 seconds, 30 seconds, 1 minute, 2 minutes, 5 minutes, or
Never.
• You may use your finger on the fader to set the delay time
• You may also use the Rotary Control to set the delay time
4.7.3 Show/Hide Settings
This is a Toggle type button. This button allows you to add
Sample Rate, Sync Source or Recall Scene to the VU or
Horizontal Meters pages
• Any or all of three choices can be selected by tapping
the check box next to each option.
• After selecting the desired choices, tap “Close”.
• The selected options will appear at the top of the
Horizontal and Analog Meter pages.
4.7.4 Analog VU Reference
You can calibrate the Analog meters to set the 0 VU level.
Using the fader on-screen or the Rotary Knob, the
0 VU mark on the meters can be calibrated between
-3dBFS and -24dBFS