Operation Manual

Page 49
4.7.5 Calibrate Touchscreen
The LCD Touchscreen has a grid that detects when you touch it to select or change settings. If you find that the touch
response gets slow or does not always engage properly, you may need to recalibrate the touch screen.
•
Push the Calibrate Touchscreen button.
• The screen will go black and give you instructions for recalibrating
the screen.
Simply follow the instructions and the previous screen will come up when
done. Be sure to touch directly in the center of the target to give the most
accurate touchscreen calibration.
With a touch screen it is easy to engage the wrong function by mistake.
This screen allows you to back out of this command if you wish.
There are times when calibrating the touchscreen is necessary for
optimum performance. However if this setting was selected
unintentionally, now you can overrule the request and return to the
Display Menu page.
4.7.6 Knob Settings
This menu allows you to select which outputs can be adjusted with the Hilo rotary encoder. By default, the Monitor
Out and the Phones Out can be attenuated with the rotary encoder, and pressing in the knob will toggle between those
two choices. If additional choices are selected from the Knob Settings menu, then pressing in the Rotary Encoder will
toggle through all the Outputs that have been selected.
• Monitor Out and Phones Out can be de-selected by clicking in
the adjoining checkboxes, and/or additional outputs can be
selected with their adjoining check boxes.
• Up to three sources can be selected at one time
• After the desired sources have been selected, turning the rotary
encoder from any Hilo screen other than the Outputs Mix
Routing page will change volume for the selected output and a
level meter will show onscreen.
• Pressing in the Rotary Encoder Knob will toggle through the
available choices.