Owners Manual

INSTALLATION
IMPORTANT NOTE: If installing on a concrete
floor, concrete fasteners are required and not
included with the anti-tip kit.
CAUTION
Any finished flooring should be protected with
appropriate material to avoid damage from
moving the unit.
If unit has been laid on its back or sides, place
unit upright and allow minimum of 24 hours
before connecting power.
1. Plug the unit into the 15 amp grounded
GFI outlet located in the installation
opening. With power applied to the unit,
check that the lighting and cooling
function operate properly, then turn off
power to the wall outlet at the circuit
breaker.
WARNING
Shut off power to the wall outlet before installing
into the opening.
2. Check that the following are level and
square:
 Front face and interior opening
 Installation opening and floor surface
 Countertop bottom front edge
IMPORTANT NOTE: Leveling legs should not
be extend more than ¾” from bottom of the
cabinet.
IMPORTANT NOTE: The floor under the unit
must be at the same level as the surrounding
finished floor.
3. If all surfaces are level:
a. Measure from the floor to the bottom of
the front edge of the countertop
b. Measure the rear of the unit cabinet
from the floor to top of cabinet, at back
corners
c. Adjust legs so B measurement is less
than A measurement. Using an
adjustable wrench or pliers, turn legs
counterclockwise to raise the unit or
clockwise to lower the unit
4. Slide the unit into position, making sure
the rear cabinet leveling legs slide under
the anti-tip devices. Push the unit into the
opening until the bottom front edge of the
cabinet is flush with the surrounding cabinetry or
the leveling legs are tight with the anti-tip
devices.
IMPORTANT NOTE:
The rear cabinet
leveling legs must be engaged under the anti-tip
brackets.
CAUTION
To prevent damage to the countertop and unit
underneath, do not place heavy objects on
countertop directly above the unit.
5. Check door openings and ensure unit is
level.