User Manual
CARE & USE/INSTALLATION
|
23
Gas connections ...continued
Insert the regulator inlet into the cylinder valve and turn the
black coupler clockwise until the coupler is hand tight. Do
not over-tighten this connection.
To disconnect the coupler, first make sure the main cylin-
der valve is turned off. Grasp the coupler and turn counter
clockwise. The inlet will then disengage.
Always leak-test the connection after refilling or exchanging
LP cylinders. (See INDEX: “Leak Test” for further details.)
GAS LINE PURGING
You should purge the gas line of air before attempting to
light the grill.
•Make sure all grill controls are in the “OFF” position.
•Slowly turn on the main gas supply.
•Turn on the gas valve and confirm that the igniter is glow-
ing. It is furthest from the fuel source and will completely
purge the lines. It will take several seconds for the burner
to light.
•The igniter will stay ON and light the burner when the air
has been removed from the line.
•Wait at least 5 minutes after shutting off the control be-
fore attempting to light the burners.
GAS CONVERSION KITS
Gas conversion kits are available from Lynx Grills to allow
the grill to operate on either Nautal gas or LPG. These kits
should be installed by a quaified technician.
The kits come with complete installation instructions. These
instructions should be read completely and fully under-
stood before installing the conversion kit.
BUILT-IN INSTALLATION
•Shut off the gas supply at the main valve.
•Disconnect all plumbing (if already attached) from the grill
and the gas supply valve.
•Remove all the fittings from the grill manifold.
•Install the side burner into the counter top cutout.
•Connect the gas supply to the grill and side burner as
shown in the two diagrams on this page.
•Turn the gas supply on and leak test all connections. (See
INDEX: “Leak Test” for further details.)
CART INSTALLATION
•Shut off the gas supply at the main valve.
•Disconnect all plumbing (if already attached) from the grill
and the gas supply valve.
•Remove all the fittings from the grill manifold.
•Install the side burner onto the cart according to the direc-
tions supplied with the cart mounting kit.
•Connect the gas supply to the grill and the side burner as
shown in the diagrams on this page for your gas type.
•Turn the gas supply on and leak test all connections. (See
INDEX: “Leak Test” for further details.)