Asado Cooktop Care & Use Manual (L30AG / L30AGF)

10 | Use&Care / Installation
UNPACKING & ASSEMBLY
The grill arrives nearly ready to use and requires only minor
assembly.
By carefully following the uncrating and unpacking steps,
you will improve the customer’s fi rst Lynx experience.
Shipping weight on smaller units is app. 300 pounds and
larger units may weigh over 500 pounds.
WARNING
EXCESSIVE WEIGHT HAZARD
Use two or more people to move or install this unit.
Failure to follow this instruction can result in back or
other personal injuries.
IMPORTANT! Do not remove staples around the top of the
carton. These staples hold a wooden pallet in place inside
the carton that protects the unit from damage. Removing
these staples may cause the pallet to fall on the top of grill.
CRATE & CARTON
How to Remove the Carton
• Cut the main strap holding the grill to the pallet.
• Remove the staples at the bottom of the carton.
• Lifto thecarton. There is a pallet over the grill for hood
protection.
• With assistance, remove the grill from the pallet and
place into desired location.
The wheels sit down in the gaps of the shipping crate so
that the grill can sit safely and solidly on the crate during
shipping. The grill cannot be slid directly o of the pallet.
One way to safely move the grill o of the pallet is by lifting
one end of the grill high enough to place a ramp under the
wheel and then lift the other end while rolling the grill o of
the pallet.
When pushing, lifting, or pulling a freestanding Lynx Grill
across gravel, grass, pavers, brick, stone, imperfections in
the surface, or wood slatted decks be cautious and move
slowly or use a carpet dolly. Failure to do so may damage
the structure of the cart which will not be covered under
warranty.
INTERIOR PACKING
Lynx uses sturdy tie-down cables and straps to ensure
your grill arrives at your home in the same condition that
it left our factory. BE SURE YOU HAVE REMOVED ALL TIE
DOWNS BEFORE USING YOUR GRILL.
• Cut and remove ties from the burner partition of the
Trident TM burner.
• Ensure that all burners are properly seated on the
burner valve orifi ce and sitting level with the legs in
the frame slots and no side-to-side movement.