Asado Cooktop Care & Use Manual (L30AG / L30AGF)

Use&Care / Installation | 13
GAS CONNECTIONS con’t
Insert the regulator inlet into the cylinder valve and turn
the black coupler clockwise until the coupler is hand
tight. Do not over-tighten this connection.
To disconnect the coupler, fi rst make sure the main
cylinder valve is turned o . Grasp the coupler and turn
counter clockwise. The inlet will then disengage.
Always leak-test the connection after refi lling or
exchanging LP cylinders. (See “Leak Test” for further
details.)
GAS LINE PURGING
You should purge the gas line of air before attempting to
light the grill.
• Make sure all grill controls are in the "OFF" position.
• Slowly turn on the main gas supply.
• Wait about 20 seconds to allow the air in the system
to purge and the burner to light
• Wait at least 5 minutes after shutting o the control
before attempting to light the burners.
NG AND LP BUILT-IN INSTALLATION
• Shuto the gas supply at the main valve.
• If connecting to a bulk propane tank, disconnect the
brass elbow, hose and regulator from the grill.
• Remove all the fi ttings from the grill manifold.
• Connect the gas supply to the grill as shown in the
diagram on this page.
• Turn the gas supply on and leak test all connections .
(See: “Leak Test” for further details.
GAS COVERSION KITS
Gas conversion kits are available from Lynx Grills to allow
the grill to operate on either Natural gas or LPG. These
kits should be installed by a qualifi ed technician or certifi ed
plumber.
The kits come with complete installation instructions. These
instructions should be read completely and fully understood
before installing the conversion kit.
LP CONVERSION KIT NG CONVERSION KIT
Inline Regulator
1/2” MxF
Street
Elbow
Angle At Least
20˚ From Horizon
Grill Manifold
1/2” MIP
Fitting
Flexible Gas Line to Inlet
Never run fl ex hose behind the fi rebox, run the hose at
an angle, straight down, or out of the back.
*Call Lynx for an inline regulator if using bulk propane