Asado Cooktop Care & Use Manual (L30AG / L30AGF)

ManualsBrandsLynx ManualsGrills30" ASADO COOKTOP BUILT-IN

Use&Care / Installation | 7

BEFORE YOU START

WARNING

• Never install this product into a combustible enclosure without an insulated jacket. Doing so could result in ﬁ re,

property damage and personal injury.

• Never locate the grill under an uprotected roof or overhang, in a building, garage, shed or other such enclosed

area.

• Never locate the grill under unprotected combustible construction.

• Installation must conform with local codes or, in the absence of local codes, with either the National Fuel Gas

Code, ANSI Z223.1/NFPA 54, Natural Gas and propane Installation Code, CSA B149.1, or Propane Storage and

Handling Code, B149.2, in Canada.

IF SHIPMENT ARRIVES DAMAGED

VISIBLE LOSS OR DAMAGE

Be certain any visible damage to the carton is noted on

freight bill or express receipt and signed by the person

making delivery. FILE CLAIM FOR DAMAGES IMMEDIATELY,

regardless of extent of damage.

IMPORTANT NOTES

HOW LONG IS YOUR RUN?

Keep all gas supply lines as short as possible because

gas lines lose pressure over distance and with each elbow

and tee that is added. This drop in pressure a ects grill

performance. (See: “Gas Supply Line Runs” for further

details.)

CONCEALED LOSS OR DAMAGE

If damage is unnoticed until the grill is unpacked, notify

the transportation company or carrier immediately and

ﬁ le a “concealed damage” claim with them. This should

be done within (5) days of the date delivery is made to

you. Be sure to hold on to the container for inspection.

We cannot assume responsibility for damage or loss

incurred in transit. (See: “Obtaining Service from Lynx”

for further details.)

ARE YOU “ON THE LEVEL”?

Proper leveling during installation is critical. A grill that

is out of level will cause erratic burner combustion and

ine cient, uneven heating. A carpenter’s spirit level

should be used to level the grill both front-to-back and

side-to-side.

BUILT-IN INSTALLATIONS

The Lynx Built-In Grill is designed for easy installation into

masonry enclosures.

NOTE: Lynx built-in grills are intended either for installation

in a built-in enclosure constructed of

non-combustible materials or for an installation in a built

in enclosure constructed of combustible material when

installed with a Lynx insulating jacket (LIJ).

For non-combustible applications, the grill drops into the

opening shown in the cutout detail drawing (See: “Gas

Requirements”) and hangs from its counter-top trim. A deck

is not required to support it from the bottom.

When using the insulated jacket in a combustible enclosure,

the jacket must be supported from the bottom by a ledge

on each side or a full deck beneath the jacket.

(See: "Gas Requirements") Pay special attention to the

provisions shown for gas line hook-up.

The enclosure should have ventilation holes to prevent

gas build-up in the event of a leak. The deck ledges

and counter should be ﬂ at and level. (refer to ANSI

Z21.58 Standard for Outdoor Cooking Gas Appliances,

Section 1.7 Enclosures For Self Contained LP-Gas Supply

Systems).

This grill requires that a 120 volt, 60 hertz, 15 amp GFI

certiﬁ ed outlet be installed by a qualiﬁ ed electrician.