Owner's Manual

ALL-SEAR CARE & USE/INSTALLATION
|
35
FINAL CHECKS ...continued
To adjust the burner low setting:
•Make sure the grill is cool.
•Remove the racks so you can see the flames while adjust-
ing the burners.
•Light the burner and allow it to pre-heat on high for 3
minutes.
•Turn the burner to “LO”.
•Pull off the control knob.
•While holding the valve shaft with pliers as shown insert a
small flat screwdriver into the center shaft and adjust the
flame’s low setting.
•Clockwise will lower the flame setting, counterclockwise
will raise it.
The proper setting is where the flame is stable at its low-
est setting. A slight flutter will be present in the crossover
portion of the front of the burner before the burner itself
becomes weak.
The factory setting for propane gas is ½ to ¾ turn from the
very bottom of the adjustment. The setting for natural gas
is 1-½ to 1-¾ from the bottom. After the low settings are
proper, turn all burners to high for visual inspection.
•The appearance of the ProSear™ 2 burner should be
visually checked. The ceramic tiles should be uniformly
red to orange in appearance. There should be no lifting,
fluttering or lazy blue flames. Some food particles will
show as yellow flames but should burn off.
IMPORTANT:
Make sure the owner knows where the main gas supply
shut off valve is located.
Finally, for safety and for proper use & care, you must
leave this manual with the owner. Make sure you advise
them to keep it for future reference.
For technical assistance call:
Lynx Customer Care
888-289-5969