MAKE THE MOST OF YOUR Lynx Electric Infrared Heater LEH39/61 CARE & USE/INSTALLATION LEH CARE & USE/INSTALLATION |1
TABLE OF CONTENTS Clearance from Combustibles 3 Warnings 4 Installation Instructions 5 Wiring Instructions 5 Mounting Instructions 6 Replacement Element Installation 7 Replacement Parts 7 Heater Coverage Areas 8 General Notes 8 Maintenance Instructions 8 Trouble Shooting 9 Location Suggestions 9 Warranty 10 This use & care manual covers the Lynx heater models listed below. Some features and options will vary based upon the model that you purchased.
CLEARANCE FROM COMBUSTIBLES SAVE THIS MANUAL FOR FUTURE REFERENCE WARNINGS- Read all instructions before using heater: Unit may be a source of possible shock. NEVER attempt to service heater without disconnecting its power source. Source of possible ignition. CAUTION-High Temperature, risk of fire, keep electrical cords, drapery, furnishings and other combustibles at least 3' (0.9m) from the front of heater and away from sides and rear. MOUNTING HEIGHT/CLEARANCES CLEARANCE FROM COMBUSTIBLES: MIN. 6" (15.
WARNINGS WARNING • Children should never be left alone or unattended in an area where this appliance is located. Install your heater well away from areas where children play. Do not store items that may interest children in or around the area of your heater. • Never touch the heater face when hot. When in use, portions of the heater are hot enough to cause severe burns. • Always maintain the required clearances from combustibles as detailed. The heater is designed for indoor or outdoor use.
INSTALLATION INSTRUCTIONS This heater must be permanently installed and hard wired by a licensed electrician in accordance with local electrical codes. Assembly procedure must be performed with no electrical power to unit. Step 1: Check UL/CUL/CE label on heater for proper voltage. Step 2: Follow supplied wiring instructions. (See wiring instructions below) Step 3: Heater must be mounted with reflector angled down.
MOUNTING INSTRUCTIONS These models may be chain or bracket mounted to any ceiling or horizontal surface. Installation must be such that 18" (45.7cm) minimum clearance is maintained around the heater on all four sides and 36" (91.4cm) directly in front. A minimum of 6" (15.24cm) of clearance provided by mounting brackets is required behind the plane of the face. Heater can be hung using chains or custom brackets. Heater must be level, but can be rotated around its horizontal axis. 6" (15.
REPLACEMENT ELEMENT INSTALLATION Disconnect the power at the breaker. Remove the grill by grasping it in the middle, flex grill up and lift it off. Unscrew and remove both end reflectors. Unhook element clips at each end of the heater and remove nuts from end of element to remove the existing quartz tube. Carefully install the new element. Remove one nut from end of the new element. Install wire by sliding high temperature ring terminal onto element screw and replace nut.
HEATER COVERAGE AREAS DUAL ELEMENT AREAS COVERED (FEET) MODEL WATTS LEH39 4,000 LEH61 6,000 MOUNTING HEIGHT AVERAGE COLD PROTECTED 8' - 12' (2.4m - 3.7m) 8' x 10' (2.4m x 3.0m) 6' x 8' (1.8m x 2.4m) 10' x 12' (3.0m x 3.7m) 10' - 14' (3.0m - 4.3m) 11' x 11' (3.4m x 3.4m) 10' x 10' (3.0m x 3.0m) 12' x 12' (3.7m x 3.7m) NOTE: Mounting height should not be less than 6' (1.8m) if the heater is labeled as UL Listed and 8' (2.4m) if the heater is labeled as CUL Listed.
TROUBLESHOOTING TROUBLESHOOTING PROBLEM WHAT TO DO Heater does not glow • Check supply voltage to confirm it matches voltage of heating element. Low heat output • A 240V element connected to 110V or 208V will warm, but not glow orange or generate sufficient heat for typical applications (Matching your voltage is extremely important). If element is visibly orange, but there is insufficient heat, refer to the areas covered with respect to conditions and mounting heights.
TROUBLESHOOTING...continued SHIPMENT DAMAGES VISIBLE LOSS OR DAMAGE CONCEALED LOSS OR DAMAGE Be certain any visible damage to the carton is noted on freight bill or express receipt and signed by the person making delivery. If damage is unnoticed until the heater is unpacked, notify the transportation company or carrier immediately and file a “concealed damage” claim with them. This should be done within (5) days of the date delivery is made to you. Be sure to hold on to the container for inspection.
ABOUT LYNX THE LYNX STORY Lynx began with a vision. LYNX SATISFIED CUSTOMERS A small group of manufacturing engineers with over a century of collective experience had a dream. They dared to take their extensive commercial manufacturing know-how and create a line of outdoor cooking products that offer commercial elegance and performance to the consumer market.
EXPLODED PARTS DIAGRAM 4 1 5 36532 36531 3 36529 3 36528 2 36526 2 36525 1 36523 SS Mounting Bracket (Set of 2) Lead Wire Set – Fits 61-1/4" (1.6m)* Lead Wire Set – Fits 39" (1.0m)* Grill Guard – Fits 61-1/4" (1.6m) Grill Guard – Fits 39" (1.0m) Body Reflector – Fits 61-1/4" (1.6m) Body Reflector – Fits 39" (1.0m) Dual Element End Reflector (Set of 2) 2 1 2 2 1 1 1 1 1 2 3 QUANTITY NEEDED 4 36533 Heating Element – Fits 39" (1.
* LYNX LIMITED WARRANTY This warranty extends to the selling dealers to the original purchaser at the original site of installation: This warranty becomes valid at the time of purchase and ends either by specified time frame listed above, owner transfer or relocation. In order to activate the warranty we require that you send in the provided warranty registration form.
The best outdoor kitchen products come from: Lynx Grills, Inc. 7300 Flores Street Downey, CA 90242 Service: (888)-289-5969 Fax: (562) 299-6978 www.lynxgrills.
