Assembly guide

Step 5.
Stick the adhesive side of the sensor to the end of the leg as shown, then carefully bend the wires to lay
along the leg. Make sure you don't try to bend the sensor tail too sharply! Secure the sensor tail and
wires to the leg as shown using electrical tape.
Note, the sensor should be centered on the flat of the aluminum hub
Step 6.
Peel an adhesive-coated bumper off of the paper, and stick it firmly on the end of the leg as shown.
Note, this should be centered precisely on top of the FSR. We chose clear rubber bumpers to make this
easier.