User Guide


LynxmotionUAV
QuadrinoNanoUserGuide


2.5.2 - Receiver & End Points
YouhavealiveviewofwhattheQuadrinoNanoreadsfromyourR/Creceiver.Stillinthe“FlightDeck”tab,lookattheReceiver
informationatthetopright.Youshouldbeabletomakethesignalsmoveoneachoftheconnections.

Note:TheReceiver,iftheQuadrinoNanoisproperlywired,canbepoweredbytheUSBcable.


WinGUIReceiverLiveView

1. ChannelsmayneedtobereversedinyourTransmittertoobtaintheproperbehavior.Theexactvalue(1000/2000)will
becalibratedinthenextstep.Ifthevalue,forexample,ismoretoward2000whenitshouldbearound1000thanyou
needtoreversethatchanneldirectioninyourTransmitter.

MultiWiiTransmitter&ReceiverSignalsValues


2. Inmosttransmitter,youwillneedtoextendtheEndPointsforeachchannelsupto120/125%andforeachdirection.You
needtoextendituntilyoureach1000to2000oneachoftheminWinGUI.




LynxmotionUAV
P.11
