User Guide


LynxmotionUAV
QuadrinoNanoUserGuide


2.2.2 Through Hole
Ifyouhaveaframethatdoesn’tallowyoutomounttheQuadrinoNanoonthecenterusingthedoublesidedtape,youcanuseour
throughholehardwareprovidedwitha30.5mmspacing.PrecautionmustbetakenwhenhandlingthebarePCB.

MaterialNeeded
● 4x256x⅞”HexScrew
● 4x⅛”NylonSpacer
● 4x#2FlatWasher
● 4x226Locknut
● 1x3/32”HexKey
● 1x5/64”HexKey

1. Removeallfour440x½”hexscrewsusingtheprovided3/32”hexkeyandopenthetopcasing.

QuadrinoNano440HexScrews

2. InsertanylonspacerineachoftherubbergrommetssurroundingtheQuadrinoNanoandclosethetopcasing.Atthis
pointyoucanusethe256screws,washerandlocknuttosecureittoyourframe.


QuadrinoNano256HexScrews

Note:Donotovertorquethescrewsasitmightleadtoabrokentopcasing.
 

LynxmotionUAV
P.4
