Lynxmotion UAV Quadrino Nano Quick Start Quadrino Nano - Quick Start V1.0 April 14, 2015 (Beta) Lynxmotion UAV P.
Lynxmotion UAV Quadrino Nano Quick Start Firmware Configuration Tool (FCT) Install FCT software ● ● Install Quadrino Firmware Config Tool (FCT) and follow the installation setup Once you have made all connections (described below) and gone through the FCT, you will need to use either MultiWiiConf or Wingui to set up your board. Both can be installed / started from the FCT (last step).
Lynxmotion UAV Quadrino Nano Quick Start Electronic Speed Controller (ESC) Wiring: Each of the ESCs need to be connected to the Quadrino Nano. One of the ESCs will power the flight controller with its internal voltage regulator (BEC), which is why only one of the ESCs’ connectors has all three wires (GND / +5V / Signal) and the other ones only have the signal wire. Use the following “MultiWii Types” to know where to connect each of your ESC’s.
Lynxmotion UAV Quadrino Nano Quick Start MultiWii Types Note that with the ATmega2560 the pins change from a standard ATmega 328 model (as it is with most of the MultiWii boards) so be sure to check. Match the name above each diagram with the “Multirotor” setting found in the Firmware Configuration Tool (FCT). Pin assignation for common MultiWii model Types Lynxmotion UAV P.
