User Guide

Lynxmotion SSC-32U Servo Controller Board
Electronics Guide
VS = VL
These two pins allow you to tie the VS1 terminal to VL (i.e. VL = VS). This would have the same
effect as running a wire from from the VS1+ screw terminal to the VL+ screw terminal.
Please refer to the power section of this guide for important information. A jumper for these pins
is not included.
VS1 = VS2
These 2x2 pins allow you to set VS1 = VS2. This would have the same effect as running a wire
from the VS1+ screw terminal to the VS2+ screw terminal. There are two jumpers to handle
higher current. The board is shipped with these in place and it is up to the user to remove them
if needed. Please refer to the power section of this guide for important information.
10