User Guide

Lynxmotion SSC-32U Servo Controller Board
Electronics Guide
A/B LEDs
There are two distinct LEDs on the board labeled A and B When not setting the Baud rate, the
LEDs indicate the following:
● Both ON at power-up before a byte is received.
● Green flashes when a valid byte is received.
● Red flashes when an invalid byte is received (framing error).
For more information, please refer to the Baud section in this guide.
5G Pins
These pins are normally not needed, and pins are not provided. Should the two capacitors
onboard not be sufficient for your application, a third capacitor can be added here. If you are not
well versed in electronics, we suggest not touching this part of the board.
13