User Guide

Lynxmotion SSC-32U Servo Controller Board
Electronics Guide
stored as 960. For example, to set to 2400 Baud, issue the command R4=240. In this case,
pressing the button will not light the LEDs, indicating the Baud rate is non-standard. (It will blink
the LEDs briefly when pressed, just so you will know something happened.)
You can read back the current Baud rate by just entering the command "R4" followed by a
carriage return.
"R4<cr>" will result in "240" if the Baud rate is 2400.
35