Specifications

STANDARD LOCKER SPECIFICATIONS
(KNOCKED DOWN)
Number Plates - Optional aluminum number plates with etched figures at least 3⁄8" high. All lockers shall have number plates attached
near top of door.
Standard Finish - Exposed steel parts shall be thoroughly cleaned, given a bonding and rust inhibitive phosphate treatment and then
electrostatically sprayed with powder coat.
NOTE: Contact Lyon for finish compatibility with any chemicals.
Anchoring - To prevent tipping or injury, Lyon strongly recommends that lockers be floor and/or wall anchored.
Free-Standing Lockers - Lockers shall be furnished with 6" legs. Optional front and end closed bases available.
Recess Trim - End and top recess trim for lockers to be placed in wall recesses shall be 18-gauge formed steel with a 2-3⁄4" wide face
and shall be bolted to locker frames. Top recess trim to be in approximately 5'0" lengths with a formed splice cap to cover joints and to
hold top recess trim in alignment. End recess trim to be 2-3⁄4" higher than lockers and will lap over ends of top recess trim for a hairline
joint at top of corners.
NOTE: There are certain sizes and/or types of lockers that are available in minimum quantity production runs only. Contact your Lyon
factory representative for complete details.
Quiet-Plus
Eliminating metal to metal contact, all Lyon locker doors are fitted with nylon lockbar guides to reduce clanging and provide smoother,
quieter operation. In addition to quieter lock bars, Lyon Quiet-Plus locker doors include a sound deadening door panel. The resulting
combination minimizes noise levels caused by opening and closing locker doors.
Spec Summary
Standard Lockers
 16-gauge door and frames
 24-gauge body parts
 One piece 16-gauge door
 Full loop type hinges
 Secure multi-point locking system
 Powder coat finish
 Built in padlock loop
 Built in locks are also available
 Fully assembled construction optional
lyonworkspace.com | PO Box 671, Aurora, IL 60507-0671 | phone [phone] | fax [phone] Page 2