Installation Guide

REPLACING YOUR OLD SINK:
Note: If replacing a sink in an existing counter top, the sink cutout in the counter top must not exceed 32⁄” or
be more than 20⁄” from the front edge. If the existing cutout exceeds these dimensions then a new counter
top is required. Measurements are based on 24” deep base cabinet and 25” counter top.
IMPORTANT - Refer to the counter top manufacturer to determine the appropriate
cutting method for your counter top.
IMPORTANT - The clip system on this sink is designed to hold it in place while the
silicone dries. If the sink opening is too large the sink can be weighed down to hold it in place while the silicone
dries. Take care not to scratch the sink if using a weight.
INSTALLATION INSTRUCTIONS
Verify that your counter top is level. Measure the false
drawer openings on the kitchen cabinet to ensure the sink
apron will cover the entire opening.
Note: If false drawer fronts are larger than the width and/
or height of the apron, ll in any gaps.
Remove false drawer fronts from the cabinet where the
apron will be located.
1.
1
Page 2
Tape the countertop surface to be cut to prevent chipping
and scratching. On the tape, mark the position of the cutout
for the sink on your counter top using the dimensions
shown. The front of your cabinet (not the counter top) to
the back of the cutout must be 20-7/16 in. Drill both top
corners using a 2” hole saw. Using a jig saw, cut out the
remaining cutout lines.
Important: do not cut cabinet while cutting the
countertop.
2a.
20-7/16 in.
32-7/16 in.
Top View of Counter
Front of Cabinet
2a
Zoom in
for step 2c
IMPORTANT
• Read installation instructions carefully before starting project.
• Keep instructions for warranty information.
• Peel back protective lm to verify color before installation.
• Do not use plumber’s putty. It will cause product failure and void warranty. Use a high
grade silicone caulk for all necessary locations.
TOOLS YOU WILL NEED:
Tape Measure
Carpenter’s Square
Straight Edge (3 Feet)
Jig Saw or Saber Saw (Fine Tooth Blade)
Masking Tape (3")
Two 3 1/2" Drains
Silicone Caulk