Installation Guide

INSTALLATION INSTRUCTIONS
REPLACING YOUR OLD SINK:
No cutting of your existing countertop is necessary. Simply place the sink in the hole and make
sure the rim of your new sink rests on your countertop. If you need to adjust the hole size, use a
saber saw or keyhole saw then continue with the instructions below.
MOUNTING SINK IN A NEW COUNTERTOP:
+ Place the sink upside down on the countertop in the desired location.
+ With a pencil, trace a line around the outside edge of the sink onto the countertop.
+ Remove sink from the countertop.
+ Measure in 7/8" and draw new lines inside the  rst sink outline just drawn. Radius corners
are not required. As a reference please see cut out dimensions on next page for your product.
+ Cut out the countertop on this new line.
+ Trial  t your sink into the hole, making sure it is centered where you want it.
+ Remove sink. Use a good grade of silicone caulk/adhesive and apply a bead under the
lip of the sink, then replace the sink in the hole.
+ Attach sink to countertop with bolts and clips provided-see below. Hand tighten bolts
only with three rotations. (Fig. 1)
IMPORTANT — Do not over tighten bolts. Sink will damage if bolts are over-tightened.
*Note: It's not necessary for the bolts and clips to be installed. Their primary purpose is to hold the sink
in place while the adhesive dries. If there isn't clearance for them, follow steps 1-7 and  ll sink with water
to hold in place while adhesive dries.
+ To  nish the job,  ll any variances between counter top and sink by sealing outside of
sink with a good grade of color-matched or clear silicone caulk/adhesive.
+ When installing drain to sink make sure to use a high grade silicone caulk.
Do not use plumber’s putty.
CARE AND CLEANING INSTRUCTIONS
+ Clean surface with nonabrasive liquid detergent and warm water. Use cleaning
products such as Soft Scrub Gel®, Comet Gel®, Gel Gloss® or other similar products.
+ DO NOT USE ABRASIVE CLEANERS, "steel wool" or wire brushes on surface. Caustic drain cleaners
may cause surface damage. Open  ames (cigarettes, candles, etc.) may damage surface.
+ Surface damage-light scratches, dulled areas, and small cuts and are restored by  rst
scrubbing with automotive-type white body cleaning compound, such as Meguire's #9
Swirl®Remover, followed by an application of Gel Gloss®. See next page for detailed Scratch
Repair Instructions.
+ Remember to always use a cutting board or sink protector when using knives or sharp
objects in your sink.
+ Recommendation: When pouring boiling water or placing hot pots or pans into the sink, run
some cold water simultaneously.
WARNING: Some cleaning products are not suitable for use. Read all labels carefully.
DO NOT USE if they say “not suitable for use with ABS, acrylic or polystyrene”.
LYONS INDUSTRIES, INC.
30000 M-62 West, Dowagiac, MI 49047
phone [phone] fax [phone]
lyonsindustries.com
e-mail [e-mail]
1/25/13
TOOLS YOU WILL NEED:
Tape Measure
Pencil
Safety Glasses
Caulk Gun
Caulk (Color Matched or Clear)
Saber Saw or Keyhole Saw
IMPORTANT
+ Before you begin, determine appropriate product reference (above).
+ Read installation instructions carefully before starting project.
+ Keep instructions for warranty information.
+ Do not use plumber’s putty. May result in product failure. Use a high grade
silicone caulk for all necessary locations.
Caulk
Sink
Caulk
Mounting Tab
Bolt
Counter Top
Sink
FIGURE 1. Attach sink to countertop as shown.