SDS

Product Name: MAGNUM* 555 ABS Resin Natural
Issue Date: 08/13/2015
Page 2 of 9
4. First-aid measures
Description of first aid measures
General advice: First Aid responders should pay attention to self-protection and use the
recommended protective clothing (chemical resistant gloves, splash protection). If potential for
exposure exists refer to Section 8 for specific personal protective equipment.
Inhalation: Move person to fresh air; if effects occur, consult a physician.
Skin Contact: Wash skin with plenty of water. Seek first aid or medical attention as needed. If molten
material comes in contact with the skin, do not apply ice but cool under ice water or running stream of
water. DO NOT attempt to remove the material from skin. Removal could result in severe tissue
damage. Seek medical attention immediately. Suitable emergency safety shower facility should be
immediately available.
Eye Contact: Flush eyes thoroughly with water for several minutes. Remove contact lenses after the
initial 1-2 minutes and continue flushing for several additional minutes. If effects occur, consult a
physician, preferably an ophthalmologist.
Ingestion: If swallowed, seek medical attention. May cause gastrointestinal blockage. Do not give
laxatives. Do not induce vomiting unless directed to do so by medical personnel.
Most important symptoms and effects, both acute and delayed
Aside from the information found under Description of first aid measures (above) and Indication of
immediate medical attention and special treatment needed (below), any additional important
symptoms and effects are described in Section 11: Toxicology Information.
Indication of immediate medical attention and special treatment needed
If burn is present, treat as any thermal burn, after decontamination. If lavage is performed, suggest
endotracheal and/or esophageal control. Danger from lung aspiration must be weighed against
toxicity when considering emptying the stomach. No specific antidote. Treatment of exposure should
be directed at the control of symptoms and the clinical condition of the patient.
5. Fire Fighting Measures
Suitable extinguishing media
Water fog or fine spray. Dry chemical fire extinguishers. Carbon dioxide fire extinguishers. Foam.
Special hazards arising from the substance or mixture
Hazardous Combustion Products: During a fire, smoke may contain the original material in addition
to combustion products of varying composition which may be toxic and/or irritating. Combustion
products may include and are not limited to: Nitrogen oxides. Carbon monoxide. Carbon dioxide.
Combustion products may include trace amounts of: Styrene. Hydrogen cyanide.
Unusual Fire and Explosion Hazards: Pneumatic conveying and other mechanical handling
operations can generate combustible dust. To reduce the potential for dust explosions, do not permit
dust to accumulate. Dense smoke is produced when product burns.
Advice for firefighters
Fire Fighting Procedures: Keep people away. Isolate fire and deny unnecessary entry. Soak
thoroughly with water to cool and prevent re-ignition. If material is molten, do not apply direct water
stream. Use fine water spray or foam. Cool surroundings with water to localize fire zone. Hand held
dry chemical or carbon dioxide extinguishers may be used for small fires.
Special Protective Equipment for Firefighters: Wear positive-pressure self-contained breathing
apparatus (SCBA) and protective fire fighting clothing (includes fire fighting helmet, coat, trousers,