Instructions / Assembly

ASSEMBLY instructions
BEFORE YOU START
• WARNING: Due to the presence of small parts during assembly, keep out of reach of children until assembly
is complete.
• Assembly should be completed by adult person(s). We intend for our products to bring joy not frustration.
Because the Follow Your Arrow
TM
Adventure Swing Series is meant to enjoy with friends too, we say invite a friend
(or someone you can spend at least 20 minutes with) to help you assemble and install your new swing.
• A flat level surface approximately 4 ft. x 4 ft. will be needed to spread out swing cover material for assembly.
• A wrench will be needed for tightening four nuts.
ASSEMBLY
1. Lay out all necessary swing components
pictured above.
2. Unfold material swing cover on level surface with
design facing up. Pull the four hook/loop straps
toward the center so the fastening side faces up.
3. Insert one curved tube through the swing
cover sleeve. Before inserting the remaining
tubes, note the direction of the first tube.
All narrow ends of tube will fit into wider
opening end of an adjoining tube. Insert the
remaining three tubes.
4. Insert all narrow ends of tube into wider end of
adjoining tube, making sure to align the
overlapping holes.
installation instructions
TREE LIMB ASSEMBLY: Test tree limb to ensure that it will hold the weight limit of 350 lbs. safely.
SWING SET OR OTHER HORIZONTAL BEAM ASSEMBLY: Attach swing to a swing set by removing two sets of swings from
the existing swing set and attach the spring clips to the chain support hooks.
1. Do not install home playground equipment over concrete, asphalt, packed earth, grass, carpet or any other hard surface.
A fall onto a hard surface can result in serious injury or death to the equipment user.
2. To prevent serious injury, children must not use the equipment until properly installed.
3. Confirm that the supporting structure is secure, it will support at least 350 lbs., is over level ground, has a minimum height
of 7 ft. and is no less than 6 ft. on all sides from vertical elements. Web swing should have a clearance of at least 1.5 times
the total length of all the rope measured from the tree limb/horizontal beam to the spring clip(s) attachment point.
4. Adjust swing hanging length so platform is parallel with ground. Bottom of swing should be no more than 24 in. and no
less than 18 in. from the ground.
18 in. minimum to 24 in. maximum
ground clearance
Rope
Tree Strap
Spring clips
At least 6 ft.
from
trunk or
1.5 times
the length of
the swing’s
rope
SINGLE ATTACHMENT EXAMPLE
CLEARANCE REQUIREMENTS DUAL ATTACHMENT EXAMPLE
5. Pull the screw ends of each rope through the slot
at the end of the straps. Insert the bolt through
the holes formed at the tubes connection points.
6. Add washer and nut to the bottom side of tube
bolt and secure. Tighten with wrench. Repeat
both Steps 5 and 6 for remaining three screw
ends and hardware.
7. Pull the hook/loop straps back over the tubing
frame and attach to the hook/loop fastener on
underside of swing.
8. Finished swing should look as pictured above.
Ropes should not cross each other above swing.