User guide

|
17
HyperControl for Logic Pro | User Guide
3. “Sends” Page
The Sends page lets you use the Encoder knobs to set effect send levels for your Logic Pro mixer tracks. You can step
through the eight effect send slots by repeatedly pressing Soft-Key 3 (Sends). The current effect send slot is listed on
the top-right of the screen (i.e., Send1, Send2, etc.).
Note that the Encoder knobs control the same Send slot across the selected bank of Logic Pro channels. For example, if
“Send1” is selected for tracks 1 – 8, turning Encoder Knob E1 will affect the first channel’s first send slot, Encoder Knob
E2 will affect the first send slot of the second channel, and so on.
✓ NOTE: You must first assign a send on your Logic Pro mixer channel before you can use
this page. If no send has been assigned, turning an Encoder Knob will not have any effect
within Logic Pro (or the Axiom Pro display).
Pressing Soft-Key 1 (Home) or Soft-Key 2 (Ins) will take you to the Home and Insert HyperControl pages, respectively.
4. “EQ” Page
The EQ page allows you to access the Logic Pro mixer’s eight-band Channel EQ. Note that you must activate the
Channel EQ on your Logic Pro mixer channel before you can use this page. If the Channel EQ has not been activated,
the Axiom Pro LCD will appear mostly blank and turning an Encoder Knob will not have any effect within Logic Pro (or the
Axiom Pro display).
HyperControl has four Channel EQ pages and each page contains parameters for two EQ bands. Pressing Soft-Key 4
(EQ) lets you step through the four pages. Note that these EQ bands are listed in the following order: 3/4, 5/6, 7/8, and
1/2. This is because bands 3/4 and 5/6 are the most commonly used “parametric” style EQs (the remaining bands are
“shelf” and high/low pass EQs).
The following table describes how the Axiom Pro knobs are mapped to the Logic Pro Channel EQ.