Fast Track Pro Quick Start Guide
USB Audio Series Quick Start Guide Installation Instructions For Windows XP PLEASE NOTE: do not connect your USB Audio series interface to your computer until the appropriate driver files have been copied to your computer. Be sure to leave your USB audio device disconnected until instructed to connect it below. 1. Insert the USB Audio Driver CD-ROM into your computer’s CD-ROM drive. 2. The computer will automatically display the interactive install screen shown below.
8. Windows will identify the new USB Audio interface and will display a “Found New Hardware” Wizard like the one seen below. 9. Choose “Install software automatically” and click “Next.” 10. Once the Wizard is completed, click “Finish.” Since there may be two components to the device driver installations that must be installed for the USB Audio series interfaces (the “bootloader” and the driver itself), you may be presented with another “Found New Hardware” Wizard.
Fast Track Pro USB Audio Series Quick Start Guide Double-click the “Open Me” icon to launch the driver selector shown below. 4. Select your product from the list on the welcome screen then click “Install Drivers.” 5. The driver installer will launch. Follow the on-screen direction prompts. English 3. 6. When the installer has completed the installation, click “Close.” 7. Connect your USB Audio interface using the cable provided and power it on. 8. Your USB Audio interface is now ready to use.
Using the USB Audio Interface Control Panel The Control Panel for each USB Audio interface is unique, so refer to your product’s User Manual located on the Driver CD. By default, the Control Panel will be set to offer output at the most common sampling rates. You’ll only have to change these settings if you are having problems or need to adjust recording parameters differently for your needs.