User's Manual

Features

Top Panel

1. Input Gain: Adjusts the input's gain level. Set this

knob so the corresponding Signal/Clip LED

(located below the knob) displays a "healthy" level

during performance—but not so high that the LED

"clips" or peaks, causing distortion in the audio.

2. Signal/Clip LED: The LED will light up green

when an input signal is detected. The LED will

light up red if the signal level is too high which

may cause distortion or “clipping”. If this occurs,

turn down the Input Gain and/or reduce the

output level from your sound source.

3. Monitor Level: Adjusts the output volume of the Main Outputs, which should be

connected to your powered monitors or amplifier system, and the Headphone Output.

4. +48V (Phantom Power) LED: This lights up when phantom power is engaged for use

with the Combo Input.

Rear Panel

1. USB Port (Type B): This connection will allow

you to send audio to and from a computer. Use

the included USB-B-to-USB-A cable to connect

the M-Track Solo to a computer. The M-Track

Solo requires a USB 2.0 connection (or higher).

2. Main Outputs: Use standard RCA cables to connect these outputs to your powered

monitors, amplifier system, etc. The mix you hear from these outputs will be determined

by the Direct/USB Switch. The level of these outputs is controlled by the Monitor Level

knob.