Installation Guide

ManualsBrandsM-D Building Products ManualsFlooringCinch 1.22 in. x 36 in. Beige Fluted Stair Edging Transition Strip

CLEAN

STEP 1

CUT

STEP 2

PEEL & ADHERE

STEP 3

CINCH

STAIR EDGING

INSTALLATION

INSTRUCTIONS:

STEP 1 - CLEAN: Make

sure the surface is

clean, dust-free, and

dry. To enhance the

adhesion, we

recommend the

surface be sealed or

primed prior to placing

tape on stair step. Not

recommended for

carpeted stair steps.

STEP 2 - CUT: Measure

and cut Cinch Stair

Edging to intended

length using a

hacksaw or power saw.

STEP 3 - PEEL &

ADHERE: Peel away

the film backing from

Cinch Stair Edging

exposing the adhesive.

With the Cinch Stair

Edge face fitting

securely up against

stair step vertical riser,

place Cinch Stair Edge

(and adhesive tape) on

the stair step. Apply

firm and consistent

pressure across the

Cinch Stair Edge in

order to properly

adhere to the surface.

Wait 60 minutes

before walking on

Cinch Stair Edging.

Note: Do not install

Cinch Stair Edging

below 50° F.

Tools Required :

Summary of content (1 pages)

PAGE 1
CLEAN STEP 2 CUT STEP 3 PEEL & ADHERE CINCH® STAIR EDGING INSTALLATION INSTRUCTIONS: STEP 1 - CLEAN: Make sure the surface is clean, dust-free, and dry. To enhance the adhesion, we recommend the surface be sealed or primed prior to placing tape on stair step. Not recommended for carpeted stair steps. STEP 2 - CUT: Measure and cut Cinch Stair Edging to intended length using a hacksaw or power saw. STEP 3 - PEEL & ADHERE: Peel away the film backing from Cinch Stair Edging exposing the adhesive.