Operation Manual

INSTRUCTION FOR INSTALLATION AND USE - LUNA 700-1000-1150-1300-1600-1900H GOLD - GAS

pic. 1

pic. 2

pic. 3

REFERENTIAL DISTANCES IN REGARDS TO FINISHING THE MANTLEPIECE

A very essential point when seing up the Luna Gold is that the distance has to be respected inbet-

ween replace and the nishing material for the mantlepiece such as marble, gipsum,...

For this, a small bended metal sheet that is provided ont the replace ( pic.1 ) , is to be used as the

minimal reference for the distance. The nishing can only ga oas far as this meteal sheet ( pic.2 ).

Don’t remove this ( pic.3 ) ! This allows you to take out the 4th side frame and to let the airow in

the mantelpiece for natural convection.

5. INSULATION AND FINISHING

Once installation is complete, the appliance can be ed. Before doing so, check the tightness of the

gas pipe one more time. Light the appliance and check that it is working: check the tightness of the

gas pipe and the smoke pipe. Once you have checked everything, you can perform the nal insula-

ting and nishing operations.

The built-in part of the furnace tends to be very warm. Please check that the furnace is not too nar-

rowly ed and that there is adequate space for the elimination of hot air. For insulation of the

furnace, we advise you to use M Design insulating plates. You are advised against using any other

insulation product. Inammable materials as well may not be used for the nishing.

Please , follow this instruction. The appliance can overheat if you not apply those instructions.

Errorcode F02 will appear !

The masonry must be raised around the furnace. Because of the expansion of the furnace

during combustion, an interstice of at least 5 mm must be provided on frontside and 4cm on

each side of the appliance. The masonry must not lean against the furnace.

THE APPLIANCE MUST BE SET FREE .

Please pay aention to leave approx. 2 mm inbetween the nishing frame and maconry

( see p.17 , mounting a 3-sided frame, and see page 37,38 and 39 for further information about

installation

min. 5 mm