Instruction Manual

Operation LS-R-4.8
22
2.3.3 Pairing the scanner with a receiver
INFORMATION
In order to pair the laser scanner with a radio-wave receiver type RC-R-100, the radio-wave receiver must be in
pairing mode (see operating instructions RC-R-100). The required pairing information is entered in the
associated PC software and then transmitted with the programming clip to the infrared interface of the LS-R-4.8
laser scanner. Afterwards, the pairing process is started.
1. Remove the cover cap from the IR stick which is inserted in the programming clip.
2. Connect the USB port of the IR stick to the PC using the associated USB cable.
3. Start the pairing program.
Pairing software
4. In the "SET Configuration" area, enter the pairing information (activation code, transmission security and
serial number of the radio-wave receiver to be paired).
5. Slide the battery compartment sleeve downwards.
6. Insert batteries as described in chapter 2.3.2.
INFORMATION
After inserting the final battery, the laser scanner will be in pairing mode for approx. 5 s. During this time, the
programming clip must be mounted and pairing must be started in the pairing software. The necessary
preparations and settings in the pairing software must therefore be carried out before inserting the batteries.