Operator`s manual

75-108 Installing the Hand Crank
The Crank package consists of
 Tail Bracket --- (1)
 Upper Bracket- (2)
 Worm Gear ---- (3)
 Crank ----------- (4)
 Spring Pin ------ (5)
 Set Screws ----- (6)
 Bolts ------------ (7)
First remove the 2 nuts and bolts (as indicated), and insert the Crank Tail bracket[1] and reinstall
with 5/8 x 2 1/4 bolts (supplied) and Locknuts.
Insert the bottom end of the worm gear [3] into the Tail Bracket, slide the top bracket [2] into
place and secure with bolts [7]. Install spring pin [5]
Slide Crank [4] into tube as shown and secure with the Set Screws [6],
Please note! When the blower is raised, the Crank will be closer to the tractor and
could damage the cab or cause injury to the operator!
1
2
3
4
5
6
7
7
Bolts
2 pc 3/8x1
2pc 3/8 Lockwasher
2pc 5/8 x 2 1/4 UNF Bolt
to replace 5/8 x 2
7