User's Manual

© 2017 M-Labs Technologies LLC 6 / 15
This LTE
product is designed based on the Sequans Communications or VZ120Q
(
LTE CAT 1, wireless data/SQN3223) b aseband module, which includes an ARM CPU, 4M serial
flash, LTE_B2&B4&B12 RF transceiver, and triple-band RF front end circuit.
Antennas for cellular and GPS are internal to the device.
2 Hardware Design
2.1 Basic Hardware
Items Requirement
Based on SQN3223 baseband chipset and
SQN3241 RF 4G Transceiver
Cellular Network Interface Support for LTE B12, B4, B2
Frequency B2(MHZ):TX(1850-1910) RX(1930-1990)
B4(MHZ): TX(1710-1755) RX(2110-2155)
B12(MHZ): TX(698-716) RX(728-746)
Antenna
Internal Dual Antennas（Main & Diversity）
[B2&B4&B12]
GPS Antenna Dedicate high performance ceramic antenna
UIM requirement
Support：2FF SIM Interrupt Mode
No Support: Hot Plug/Unplug
Battery Monitor Internal analog input
Build in battery manager Yes
Interface
Debug UART
Application UART
USB
12V DC Input（1A current）, Ground
Relay Drive (12V Output ,500mA current)
Dedicated Output for buzzer control
Ignition Input
GPIO
Dedicate Timers Yes
Watchdog External HW via MCU
Motion Detect
Supported（GPS/G-Sensor）
LED 2 LED Supported
1- RED; 1- Green
Battery
Build in battery（80MAH Lion）
Working Time 4 hours
Power switch
No
Power Cable color 10 colors
Power Cable connector type 10-pin connector
Power Consumption < 5Watts
US130Q LTE E-UTRA
Baseband Module
US130Q LTE E-UTRA
4G