User manual

english 11
MANUAL
LED BEDLIGHT SENSOR
Mounting
The bending radius of this product is limited to 20 mm.
Do not cut the LED Bedlights!
1. The LED Bedlight(s) and the cable(s) must be unwound and installed
without twisting.
2. Only applies to item 400225: Connect the power unit with the Y-connector.
With both items: Connect the sensor(s) with the LED Bedlight(s) and the
power unit.
3. Fasten the LED Bedlight(s) and the sensor(s) in the desired position on
the bed frame for example, with the double-sided adhesive tape, and
secure the cables with the fastening clips.
4. Plug the line adapter into the socket.
5. By turning, it is possible to release the sensor(s) from the rear side stuck
to the frame and individually set the lighting time after triggering by
movement (30 sec. - 10 min.).
20 mm
LED-Bedlight 1
Sensor 1
LED-Bedlight 2
Sensor 2
Netzteil
10 min
30 sec
Time adjust