User manual

Mounting
 1.  Estimatethepositionofholdingclipsorglueares
2. Assembly the sticks with the connectors and check the
   positionoftheholdingclipsorplacethegluepadsonthe
sticks
 3.  Pushthesticksintotheholdingclipsor
   gluethesticksonthedesiredplace
 5.  Puttheendcaponthelaststick
 6.  Connecttherststickwiththelineadapter
 7.  Connectthelineadaptertothepowersocket
 8.  Removethecontactprotectioninthebatterycompartment
 9.  StarttheLEDstripbyusingtheremotecontrol
10. Advice :
   Receiverfortheinfrared-signalsoftheremoteisthe
   repeater.Theremotecontrolneedadirectandbarrier-free
   connectiontotherepeater.Max.distance5-7m.
Battery replacement
Pleaseopenthebatterycompartmentonthesideoftheremote
controlbypushingtheclampingpinbysimultaneously
extractingthecompartment.
PleasealwaysuseanidenticalbatteryoftypeCR2025· 3 V.
Pleaseconsidercorrectpolingbyplacingthebatteryinthe
compartment.Thesideofthepositivepoleismarkedby(+)
onthecompartment.
english 13
MANUAL RGB STICKS