Instructions
TECHNICAL MANUAL GS 3x.10 KNX – ENGLISH
4
Overview parameters
Parameters
Subcategory parameters
Description
Global
settings
Global settings
Send „in operation “(incl. cycle time), request status (active/inactive, request with…), send delay after bus voltage recovers in seconds.
Relative
humidity
sensor
Relative humidity sensor
Settings humidity sensor: Enable – disable, send measured values, offset adjustment, notification of sensor error, external value
enabled/disabled.
Relative humidity control
Settings humidity control: Type (inactive, 1-/2-/3-step, PI), output format, send on change / send cyclically, hysteresis (symmetrical).
Threshold 1,2,3, switching command above / below threshold, control value, blocking object
Temperature
Temperature sensor
Settings temperature sensor: Enable – disable, send measured values, offset adjustment, notification of sensor error, external value
enabled/disabled.
Temperature alarms
Settings frost- and/or heat alarms: Enable – disable, send measured values.
Temperature control
Settings temperature control: Type (inactive, heating, cooling, heating & cooling), different control values (extra cooling level & guide).
Dew point
Dew point temperature
Settings dew point: Enable – disable, send measured values.
Dew point alarm
Settings dew point alarm: Enable – disable, send measured values., hysteresis (symmetrical), switching command on alarm.
Air pressure
Air pressure sensor
Settings Air pressure-Sensor: Enable – disable, send measured values, notification of sensor error, elevation.
VAV control
Settings
Settings VAV control: Enable – disable for different (already configured) PI controls, send control values according to defined parameters
and values.
Inputs
General
E1…E5 general
E1…E5 parameters
Limitation of number and interval of telegrams to be send
Labeling of inputs, selection of function as analogue-/binary-/temperature input (functions depending on input)
Binary input: switching/alarm, dimming, blinds/shutters, value, scene, switching sequences, multiple operation, pulse counter
Analogue input (E1 only): Voltage, upper/lower measuring limits, output value, threshhold, limits changeable via bus
Temperature sensor input (E4/5 only): Function temperature / temperature limiter floor heater, sensor type, offset, error compensation,
threshold 1, threshold 2