Owner Manual

INSTALLATION

1. Attached Rope To Disk - Thread rope through center hole in disk and tie a double knot

as shown below.

2. Do not install Disc Swing over concrete, asphalt, packed earth, or any other hard

surface. See page 6 for more information on proper protective surfacing material.

3. Con rm that the supporting structure is secure, it will support at least 200 pounds, is

over level ground, and is no less than 6 ft on all sides from vertical elements.

4. Tree Limb Assembly -Test tree limb to ensure that it will hold the weight limit of 200

lbs. safely. Obtain additional rope to attach the Disc Swing to the horizontal support. The

rope used should not be less than the quality, durability, and strength of UV stabilized,

3/8” twisted or braided polyester rope. Form a small noose at one end of your rope and

throw it over the tree limb. Run the other end of rope through the noose you created and

tighten  rmly. Run the end of rope through the loop on the Disc Swing. Tie a minimum of

TWO tight knots  rmly. Attach swing with a carabiner rated for maximum weight. Bottom

of swing should be no less than 15 in. from ground.

5. Swing set or other horizontal beam Assembly - Attach the Disc Swing to a swing

set by removing one set of chains from an existing swing. For easiest attachment, use a

carabiner rated for a maximum weight of 200lbs. Clip the carabiner to the swing set loop

and then to the upper loop of the Disc Swing. The bottom of swing should be no less than

15 in. from ground. (See  g.3)

Double overhand knot

Pull tight

More Fun Products from

Big Buck Tire Swing - MM00114

Chopper Ride’n Tire Swing - MM00117

Air Riderz

Extreme

MM00118

Air Riderz

with Disk

MM00128

Pony Pal Tire Swing - MM00107

WebRiderz Swing - MM00124