User Manual

The first thing you will need to do is to locate an area over which you wish to monitor

speeds. This area will need two distinct landmarks so that you observe when the

vehicle has passed each landmark so that you can accurately start and stop the timer.

You will need to know with good precision how far apart the two landmarks are.

In order to get the best accuracy in stopwatch mode, the measurement time for a

vehicle to traverse the distance you select should be at least 10 seconds. Therefore,

you will want the landmarks to be at least 100 yards apart for city use and several

hundred yards apart in the country.

Next, you need to tell the radar how far apart the landmarks are. The first time you

operate the stopwatch mode, the distance will be preset to 100 yards. Each press of

the “+” key will increase the distance by 1 yard and each press of the “—” key will

decrease the distance by 1 yard. Also, each press of the Same key increases the

distance by 10 yards and each press of the Opposite key decreases the distance by 10

yards. Finally, each press of the Front key increases the distance by 100 yards, while

each press of the Rear key decreases the distance by 100 yards.

The timer is started and stopped by pressing the Lock button. To measure a vehicle’s

speed, you must press the Lock button when the vehicle is passing the first landmark.

When the vehicle has reached the second landmark, you should press the Lock button

again. The timer in the Target window will freeze, and the calculated speed of the

vehicle will be displayed in the middle window. Since this is a locked target speed, the

T-lock indicator will be lighted under the middle speed window.

To measure the next vehicle, just press the Lock button. The speed from the previous

vehicle will be cleared, and the time will start at zero. To exit the stopwatch mode,

press the Menu or Mov/Sta key.