Installation Guide

M-ROCK P-Series /MSI
INSTALLATION OF MSI P-SERIES
(PANELIZED STONE SERIES)
STACK & FASTEN TECHNOLOGY
M-Rock Stone Manufacturing has quickly become the name to know
when it comes to manufactured stone products. M-Rock is expanding our
product lines with the new MSI technology. The new MSI, (Mortarless
Stone Innovations) takes the mess, mortar and mason out of your stone
installation.
READ:
• Read the instructions and know what your local building codes
require.
• Ensure that you have all the tools and supplies you will need.
• We are here to help, just call customer service 866-896-7625.
PREPPING THE SURFACE
Exterior Untreated Wood Installation: For exterior untreated wood installation a moisture barrier of 30# felt doubled or a
synthetic barrier is required.
Exterior Treated Wood Installation: Moisture barrier of 2 layers of 30# felt is recommended when using treated plywood.
Interior Wood Installation: Moisture barrier is recommended
Interior Dry Wall: MSI can be installed over Dry Wall, 1) Hit one stud per stone, or 2) Use some type of dry wall anchor.
Block Installation: MSI can be installed over block using 2 layers if 30# felt and masonry screws to apply stone to block.
We recommend that the block be sealed before MSI installation.
STEP 1: STARTING OFF RIGHT
After applying your moisture barrier the starter strip is your first step with
MSI P-Series Stone. It will be installed the length of your project area and
it needs to be installed level. The starter strip is what your first row of stone
will lock onto. Drill through the channel of the starter strip. Each starter strip
should be installed with two screws as shown in the photo to the right. Install
starter strip 1 3/4” above the surface of your project area making sure that
you keep starter strip straight and level.
STEP 2: FIRST ROW OF MSI
When inside and/or outside corners are present it is recommended that you start with inside
corners first, then outside corners, then fill in between with flats. The first row locks onto the
Starter Strip and the stones work better from left to right. When you get to the end of the
each row measure and make the appropriate cut, using the remaining piece to begin your
next row.
STEP 3: SECOND ROW AND CONTINUING
Your second row and all following rows will stack and fasten directly onto the previous row
of MSI stone. Make cuts where necessary, staggering each row. By staggering your rows
you avoid vertical seams. Be sure to use your cut pieces in and throughout your project.
MSI has been designed for minimal waste, but that requires using your cut pieces to fill in
where needed. If you do not reuse you may run short.
SUPPLIES YOU WILL/MAY NEED:
Along with your MSI Flats/Corners
• Starter Strip Packs and a level
• Drill and appropriate driver
• Drywall screws for interior application
• Exterior grade screws for exterior application
• Recommended 30# Felt doubled moisture barrier
• Polyurethane Construction Adhesive
• Masonry, circular or table saw with diamond blade
• Universal Trim or Transition Molding
TIP: Put cuts of similar stones together.