User manual

Special Notice on Water Treatment
Please read about water quality and filter in user manual. Always shower before you enter your MSpa!
Please use test strip to test your water chemistry before each use of the spa, no less than once per week.
The pH level must be between 7.2 and 7.8, total alkalinity between 80 and 120ppm and free chlorine
between 3 to 5ppm. Too low of a pH level will result in excessive wrinkles and damage to the spa pool as
well as corrosion in the motor unit. Too high of a pH level(hard water) will result in scale incrustation, e.g.
sheets of white coagulations inside the filter pump, which will lead to block and non-working of the filter
pump.
If you have any questions regarding chemicals, please contact local spa and pool water treatment special-
ist stores.
It is the responsibility of the owner to properly maintain the chemical balance and sanitation of the water.
Mspa is not responsible for any damages that result from improperly mantained water. Improper water
maintenance may result in voiding the warranty.
Spa Cleaning
Detergent residues or dissolved solids from bathing suits and chemicals will gradually accumulated in the
water. If any dirt is visible in the water, change the water and clean the pool. Use a mild cleaner to wash
the inner vinyl of the spa tub and rinse with clean luke warm water.
NOTE: Do not use hard brushes or abrasive cleaners.
Drainage
1. Turn off all the buttons on the control panel.
2. Unscrew the valve on outside of the spa pool till it is detached from the drainage structure.
3. Connect the black drainage hose on to the drainage structure. Make sure it is well connected and the
other end of the drainage hose is connected to a ground drain.
4. Pull and open the cover of the drainage structure inside of the spa pool, water will flow out from the
drainage hose.
5. Tilt the spa until no water flow out to empty the spa completely.
DO NOT leave your MSpa full of water if you will be away for awhile and no one can take care of the
pool. Drain the water before you leave and deflate the spa pool body a bit.
Spa Pool Repair
If the spa pool body is damaged, use the repair patch provided in the package. Clean and dry the dam-
aged area in order to prevent dust and dirt from getting on the tacky glue. Apply glue to the PVC of the
repair patch and quickly attach it onto the damaged surface. Smooth the surface to remove any air bubbles
and allow it dry for roughly 3-10 minutes. A secure and unnoticeable can usually be made.
Spa Storage
After the spa is drained, operate the Bubble function for another 20 minutes to dry the bottom ring. Remove
the control panel from the spa tub, disassemble filter pump from the bottom of control box so as shown
in the video. Drain the water and clean off any scale incrustation, like white coagulations inside the filter
pump. Unscrew the complete part of the air valve on the spa pool and the spa will be deflated.
NOTE:
1. In the process of dismantling the filter pump, please check that there should not be any sharp objects
on the ground to damage the spa tub. The connector of the air pipe on the control box is exposed, please
handle with extra care. You can put some underlay under the spa tub to ease the weight, this also helps
avoiding damage of friction.
11