User manual

B. RCD Test

WARNING: RISK OF ELECTRIC SHOCK. The RCD plug must be tested before each use.

WARNING: Insert the RCD plug into a residual current device (RCD) protected power receptacle only.

WARNING: Before inserting the plug into a power receptacle, make sure the current rate of the power

receptacle and the ﬁxed wiring are suitable for the Spa. Contact a qualiﬁed electrician if you cannot verify.

1. Insert the plug into the power receptacle. (1)

2. Press the “RESET” button. The indicator area should turn red. (2)

3. Then press the “TEST” button. The indicator area should disappear. (3)

WARNING: Do not use if above test fails.

4. Finally, press the “RESET” button again. The indicator area should turn red. The spa is ready for use. (4)

C. Assembly

a) Unfold the Spa pool from the packaging. Take out the spa pool body, cover and temp barrier mat. Make sure spa and

cover top are right side up. Put temp barrier mat(optional) under the spa tub.

Note: B-100 includes a side bar, which needs to be placed before ﬁlling water to the tub. The side bar helps

keeping the spa pool in its proper shape after ﬁlling.

Temp barrier mat (optional) can prevent heat loss from bottom of the unit and provide better heat preservation with to-

gether of the inﬂatable bladder (optional) being used.

It is possible to install and leave the spa tub outside at a temperature below 4°C, but only if the water temperature inside

the pool is higher than 4°C and water in pipe is not frozen. The spa tub can be operated in cold weather with tempera-

ture down to maximum -10°C if the unit is properly set up and no frozen water inside the control box, pipes or spa pool.

It’s helpful to put temp barrier mat in between the spa pool and the ground. Similar mat which is made of foam material

or other materials with temp barrier function can also be used.

Don’t install Mspa onto the lawn as grass may cause air pump damped and rusted which could result the air pump

works improperly and will void your warranty.

) Screw the control panel onto the spa tub, fasten the ring to the pipe adaptor.

Precautions:

1. When using the spa tub outside, air pipe can not be taken off. Do not use the

spa tub in rains as air pump will not working properly.

2. The two O-ring part on the air pipe is important to get the spa tub working

properly. Lost of the O-rings could cause air pump rusted or not working properly.

Missing of the O-rings also affects bubbling function.

For models coming with outer pool cover, put the side leather cover

on the spa tub.

Attention: make sure the 2 holes on the leather cover ﬁt the right

positions of spa tub.

(b)

(c)