Use and Care Manual

INSTRUCTIONS

NOTE: Ensure to check all parts are present.

A: Aluminium foil top lid and zipper 1pc

B: Control panel 1set

C: Spa pool 1pc

D: Temp barrier mat (optional) 1pc

E: Digital lock 1pc

F: Ination Hose 1pc

G: Filter cartridge 2pcs

H: Drainage hose 1pc

I: Repair kit 1set

J: Manometer 1pc

K: Inatable bladder (optional) 1pc

A. Site Requirements

WARNING: The oor has to be capable of supporting the expected load of the spa tub.

WARNING: An adequate drainage system has to be provided to deal with overow water.

IMPORTANT: It is extremely important to make sure the spa tub is placed on a structurally-sound surface which will sup-

port the weight of the spa, water, and occupants. Flat, smooth and supporting surface is required. Uneven or unsound

surfaces can damage the tub and void your warranty. Regardless, it is your responsibility to make sure the site is prop-

erly prepared, whether on the ground, on a oor, deck, patio or slab. Level the surface before lling spa with water.

a) Indoor Installation:

Indoor installations have special considerations, be aware of following requirements.

• Verify the supporting oor structure will accommodate the lled weight of the spa with occupants. A qualied contractor

or a structural engineer can help to determine the requirements. The oor where the spa tub is installed must be a non-

slip and at surface.

• A proper drain is essential to indoor installation. Select ooring which provides a good grip for wet feet.

• Humidity is a naturally side effect of indoor spa installation. Determine the effects of airborne moisture on exposed

wood, paper and etc in the proposed location. The room should be properly ventilated to allow moisture to escape. In-

stallation of a bathroom fan or other venting system is a good idea to prevent excess condensation in the room.

Note: Do not install the spa tub on a carpet or any other materials that could be damaged by moisture.

b) Outdoor Installation:

WARNING: TO AVOID THE ELECTRIC SHOCK, DO NOT USE THE SPA IN THE RAINS.

It is important to install the spa tub on a rm level surface. If the spa tub is installed outdoors, make sure there are no

sharp objects that could damage the unit. The surface must be at so the spa tub will be placed rmly and properly.

• If outdoors, make sure that the site has adequate drainage so water splashed out during lling, emptying or using the

spa will not be able to pool around the spa.

• Do not leave the spa tub exposed to direct sunshine for an extended period.

Note:

1. It is important only to use a 16A (13A for UK) power supply.

2. If have to use an extension cord/connecting cable, please make sure it is for 16A (13A for UK) purpose and

for outdoor use.

3. For safety reasons, set up spa tub at least a few meters away from power supply and within line of slight of

the spa for safety.