Use and Care Manual

c) Connect the pin plugs. Make sure that plugs are properly matched together, screw a cap, and then you’

ll see yellow light on control panel, no bent or wet for the pin inside male connector which will cause failure

connection.

d) Open the air valve under the control panel. Screw one end of ination hose onto it.

e) Unscrew the top part of air valve on the Spa. Screw the other end of ination hose onto Manometer, and

then put into the air valve.

f) As previously outlined, test spa’s RCD plug. Press the “ON/OFF” button on the control panel, then inate

the spa pool by pressing the “bubble” button.

(d) (e) (f)

g) Please check and test the air pressure status inside the spa pool in the following ways:

Please read the dial plate of manometer.

DO NOT OVER INFLATE. OVER INFLATION MAY CAUSE SPA POOL LEAKAGE AND VOID THE MAN-

UFACTURER WARRANTY.

h) Press the “bubble” button again to stop inating. Remove the ination hose from the air valve on the spa

pool. Screw the cover to the valve once the air pressure inside the pool is tested to be suitable.

i) Connect the ination hose to the air valve of inatable bladder(optional) and then press the “bubble” but-

ton on the control panel to inate it. When it’s going to be full without wrinkles on surface, please press the

“bubble” button again to shut off and stop inating.

After lling in water, please check air pressure again and make sure the pin reads in

green sector.

When needs to inate more air during use, please make sure it reads in green sector in

any term.

If it points to red sector, the spa is over inated. Please unscrew the valve and release

some air.

Recheck the air pressure and make sure it reads within the green sector.

Please press the black button on the manometer, and air will be let out from the position

where the button locates. Keep pressing the button till the pin points to the green area.

If it points to yellow sector, the spa is well inated. You may ll in water now.

To avoid over ination caused by warm weather or sunshine when leaving mspa

for weeks inated and lled with water in temperature higher than 20°c, please

reduce the air pressure to the yellow sector of manometer.