Owner`s manual

104

O-rings

Air pipe

Connect the control panel to the spa tub. Fasten and secure the rings to

the pipe adapter on the spa tub (Fig. 5) Make sure the rubber O-rings are

properly placed on the air pipes.

CAUTION: Loss of the O-rings may cause the spa and bubbling function to

work improperly, and cause the air pump to rust.

NOTE: For spa models with PVC leather covers, make sure the spa cover

is on the spa tub properly before connecting the control panel. The two

holes on the leather cover must be positioned correctly on the control panel

air pipes.

Spa Inflation.

6.1 Unscrew the air valve cap (a) on the control panel to reveal the air blower inflation outlet. Connect one end of the inflation

hose (b) to the outlet. (Fig. 6.1).

6.2 Unscrew the air valve cap on the spa pool to reveal the stem for inflation.

6.3 Connect the other end of the inflation hose (b) to the manometer (c) and then insert it into the air valve.

6.4 Press the Bubble button to inflate the spa tub until it is firm to touch.

CAUTION: Do not over inflate. Over inflation may cause the spa to leak and will void the warranty.

6.5 Pay attention to the manometer. The yellow section appears when the spa is properly inflated. The green section shows

when water filling is completed. Repeat previous steps if more air is necessary.

CAUTION: The red section shows when the spa is over inflated. Press the black button (a) on the manometer to release

some air until the green section appears.

IMPORTANT: During spa use, the manometer should only shows the green section at all times.

6.6 When inflation is completed. Press Bubble button again to turn it off. Disconnect the inflation hose on both ends.

Replace the air valve cap.

6.1

6.2

6.3

6.4 6.5

Green

Yellow

Over Inflation

Red

Button

(a)

(b)

(c)

(a)