Owner`s manual

13
Spa Bladder Inflation. (*Optional for MSpa LITE)
7.1 Open the air valve (a) on the bladder. Insert the inflation hose (b)
into the valve.
7.2 Press the Bubble button to inflate until the bladder is firm
to touch but not hard.
7.3 Press the Bubble button again to stop inflation. Disconnect
the inflation hose from the air blower outlet and the valve.
7.4 Replace the air valve cap (c) on the control panel. Close
and recess the inflation valve (a).
7.
7
Water level must reach the MIN. water line but not exceed the MAX. line to avoid pump failure.
Never pour water with a temperature higher than 104°F(40°C) into the spa directly.
To avoid control system failure, do not operate the spa until water reaches the MIN. line.
●
●
●
Spa Deflation.
8.1 Unscrew the air valve cap on the spa pool to deflate the spa.
8.2 Once the deflation is completed, replace the cap.
Spa Bladder Deflation. (*Optional for MSpa LITE)
9.1 Pull the valve cap out and squeeze the valve at its base until deflated.
9.2 Close and recess the valve back.
Water Filling
10.1 Ensure the spa liner is at the selected area and point the drain
valve toward a suitable draining area before inflation.
10.2 Fill the spa tub with fresh water to a level between the MINIMUM
and MAXIMUM lines marked on the inside of the spa wall.
Do not over fill the spa. It is recommended to fill the spa with
lukewarm water for quick heating and energy saving.
WARNING:
10.3 After filling with water, double check the spa pool air pressure to make sure the manometer points to the green section.
10.4 Place the inflated air bladder and the zipper spa cover over the spa tub. Make sure the spa cover zipper is closed
and lock the cover with the digital lock in the accessory pack.
IMPORTANT:
● Inspect the spa pressure regularly for leaks, premature wear or deterioration.
● Check and wax the zipper regularly to make it make it operate smoothly and to avoid splits.
8.
9.
10.
(a)
(b)
(c)
10
10.4
The cap is designed to be screwed on and off. Never exert force, as this could cause the compete internal inflation system of
the valve to come loose.
If over inflated, remove the inflation hose from the spa air valve side, unscrew the valve cap to release some air until the
manometer points to the right colour section.
●
●
NOTE: