Manualshelf

Owner`s manual

ManualsBrandsM-Spa ManualsHome building and DecorNest
11121314151617181920
15
ºC
CONTROL PANEL OPERATION
1. ON/OFF button
2. Bubble button
3. Water filter button
4. Heater button
5. Temperature adjustment buttons
6. Temperature button
7. Celsius/Fahrenheit toggle button
1
2
3
45
6
7
ON/OFF
ON/OFF button: To activate the control panel.
Bubble button: To activate the bubbling massage function, which automatically turns off for 20 minutes after being
on for 10 minutes. The bubble button light is green when activated.
Water filter button: To activate the filter pump. The filter button light is green when the filtration system is
activated. FILTER light will be off when temperature reaches pre-set level.　
NOTE: Filtration cannot be turned off when heating is activated.
Heater button: Use this button to active the HEATING and FILTRATION function at the same time. The heater will
heat the spa water until the water temperature reaches the pre-set temperature. After the current water temperature
drops 3.6°F (2°C) below the set temperature, the heating system will restart automatically. When the HEATER
button is red, the heating system is activated. When the HEATER button is green, the heating system is at rest as
the filtration system is inactive or the water is at the set temperature.
Temperature button: To display the water temperature. The control panel displays the SET temperature when
the temperature button is pressed once and then shows CURRENT water temperature after one second.
NOTE: The default temperature is 100°F (38°C).
NOTE: Temperature adjustment ranges from 68°F (20°C) to 104°F (40°C).
Temperature adjustment buttons: To adjust the temperature. After pressing the TEMPERATURE button for
three seconds, the LED starts to flash, then you can set your desired temperature by pressing the increase or
decrease buttons. After the desired temperature is set, you can press the TEMPERATURE button again or wait for
10 seconds to see the current water temperature.
Celsius/Fahrenheit toggle button: The temperature can be displayed in either Celsius or Fahrenheit. The
system’s default is Celsius.
ºF
104
F