Owner`s manual

Reinstall the clean or spare cartridge onto the spa tub wall by turning it clockwise (Fig.1.3).●

Press the bubble button on the spa control panel to turn on the bubble air blower and help dissolve the chemicals into

the water.

Never mix chemicals together. Add the chemicals to the spa water separately.

Thoroughly dissolve each chemical before adding to the water.

●

1.1 1.2 1.3

ONLY install the filter

cartridge here!

ONLY install the filter

cartridge here!

2. Change the spa water every three to five days, depending on the spa use. See “Cleaning, draining and storage” section for

instructions.

3. Use spa chemicals to maintain proper water chemistry. Spa damage resulting from misuse of chemicals and mismanagement

of spa water is not covered by the warranty. Consult with your local spa or pool retailer for more information on chemical use.

4. All occupants must shower before entering the spa.

5. When spa inlet or outlet is stuck with dirt, use the wrench to check the

problem and clean the inlet or outlet.

Water Balance

Maintain the spa water pH level between 7.2 and 7.8, total alkalinity between 80

and 120 ppm and free chlorine level between 3 to 5 ppm. Use the *optional

test strips to test the spa water chemistry before each use of the spa and continue to test the water no less than once a week.

The test strips can test the “Free Chlorine,” “pH” and “Total Alkalinity” levels at the same time:

1. Dip the entire strip into the water and remove immediately.

2. Hold the strip level for 15 seconds. Do not shake excess water from the strip.

3. Compare the strip pad to the colour chart on the packaging label. If necessary, adjust the chemical level in the pool water.

NOTE:

● Low pH will damage the spa tub and pump. Damage resulting from the chemical imbalance will void the warranty.

● High pH (hard water) will result in white coagulations inside the filter pump; which may lead to pump damage.

IMPORTANT: