Operation Manual

30
REPLACING THE OVEN LIGHT (fig. 4.2)
Before any maintenance is started involv-
ing electrical parts of the appliance, it must
be disconnected from the power supply.
– Let the oven cavity and the heating ele-
ments cool down;
– Switch off the electrical supply;
– Unscrew the protective cover (fig. 4.2);
– Unscrew and replace the bulb with a
new one suitable for high temperatures
(300°C) having the following specifica-
tions: 230-240V 50 Hz, 15W, E14
– Refit the protective cover
NOTE: Oven bulb replacement is not cov-
ered by your guarantee.
Fig. 4.3
A
B
Fig. 4.2
OVEN FITTING OUT
The oven shelves are provided with a secu-
rity block to prevent accidental extraction.
They must be inserted operating as per
figure 4.3.
To pull them out operate in the inverse
order.
STAINLESS STEEL SURFACES WITH ANTI-FINGERPRINT TREATMENT
CAUTION:
The stainless steel surfaces used in some ovens are protected with a Special Lacquer
to reduce finger-print marks.
To avoid damaging this lacquer, do not clean the stainless steel with abrasive cleaners or
abrasive cloths or scouring pads.
ONLY SOAP/WARM WATER MUST BE USED TO CLEAN THE STAINLESS STEEL
SURFACES.
Fig. 4.1
GREASE FILTER (some models only)
– Slide in the grease filter on the back of
the oven as in fig. 4.1.
– Clean the filter after any cooking!
The grease filter can be removed for
cleaning and should be washed regular-
ly in hot soapy water (fig. 4.1).
– Always dry the filter properly before
fitting it back into the oven.
CAUTION: THE FILTER MUST BE
TAKEN OUT OF THE OVEN BEFORE
STARTING THE PYROLYSIS CYCLE.